Rev. 20220502
iArmor
®
Customer Support: [email protected]
5
STEP 5
Once all (4) Mounting Brackets have been installed, attach the
Driver Side Step Bar to the Mounting Brackets with (8)
M10X1.5-25 Hex Bolts, (16) M10 Flat Washers and (8)
M10X1.5 Nylon Lock Nuts,
(Fig 10)
. Do not fully tighten hard-
ware at this time.
STEP 6
Properly level and adjust the Step Bar and fully tighten all hard-
ware.
Attention
Do periodic inspections to the installation to make sure
that all hardware is secure and tight.
In order to protect your bars/boards, please use mild
soap/non-abrasive products for cleaning only.
STEP 7
Move to the other side of the vehicle. Repeat
Steps 1-6
for the
other Side Step Bar installation.
(Fig 10) Driver Side Step Bar Installation
(8) M10X1.5-25 Hex Bolts
(16) M10 Flat Washers
(8) M10X1.5 Nylon Lock Nuts
Front
DCM1
DFM/PCM/DRM
Bottom View
DFM/PCM/DRM
DCM
