Rev. 20211001
3
iArmor
®
Customer Support: [email protected]
STEP 1
Install the Step Pads onto the step bars with (32) M6x1-20mm
T-Bolts, (32) M6 Flat Washers and (32) M6x1 Nylon Lock Nuts.
IMPORTANT:
Don’t hit the step pad by any metal hummer
within step pad installation, or the step pad will be damaged.
The instruction here is for your reference only. We strongly
recommend the professional installer for best result. We are not
responsible for any damage caused by the installation.
STEP 2
Start the installation from the driver/left side of the vehicle. Lo-
cate the Driver Side Mounting Locations along the inner side of
the body panel,
(Fig 1)
.
(8) M6X1-20mm T-Bolts
(8) M6 Flat Washers
(8) M6X1 Nylon Lock Nuts
Note: Rotate 90° after inserting the T-Bolts
into the Channel!!!
STEP 3
Slide (1) M8 Plastic Washer over each of the (3) factory mount-
ing studs on the body panel,
(Fig 2)
.
IMPORTANT
: The Plastic
Washers are designed to prevent corrosion between the alumi-
num body panel and the steel mounting brackets.
Do not in-
stall the Brackets without the Plastic Washers
.
(Fig 1) Typical mounting location
(Fig 2) Thread M8 Plastic Washers onto all mounting studs
M8 Plastic Washers
STEP 4
Attach the Driver Front Mounting Bracket to the (3) factory
studs with (3) M8 Flat Washers and (3) M8X1.25 Nylon Lock
Nuts,
(Fig 3)
. Do not fully tighten hardware at this time.
(Fig 3) Driver Front Mounting Bracket Installed
Front
(3) M8 Flat Washers
(3) M8X1.25 Nylon Lock Nuts
