MAN – 086 – ENG - 13
Once the correct clearance is achieved, disassemble the crankcase cleaning the surface with diluent
and apply liquid gasket (Motorseal or equivalent) on one side of crankcase half. Be careful to clean
eventual excess of product. Lubricate crankshaft seat before insertion, prevent oil from falling onto
liquid gasket.
Reassemble crankcase. Fixing n°7 Screws (n°5 M6x45 n°3 M6x60), tighten with ALLEN WRENCH
5mm. Tighten with a torque of 10 Nm (90 lb-in).
Where necessary change the oil seal, apply special grease on lips before inserting (mark on seal to
be outside), use special tool as in drawing S 725 / 1.
11
