Step 6/11
Numbered annotations (1)
4
Step 7/11
Numbered annotations (1)
5
4
Line up the holes in the cup holder
bracket where the two T20 torx
screws were previously removed.
Start threading the screws through
the cup holder bracket into the
console cover but do not tighten fully.
5
*Special Note*
The cupholder bracket should be
adjusted up as close as possible to
the console cover if your Bronco is
equipped with floor mats that cover
the transmission hump. The
cupholder bracket should be adjusted
down towards the bottom of the
console cover if you do not have floor
mats.
IAG-ACC-F3067 - IAG Removable Dual Rear Cupholder for Two Door & Four Door 2021+ Ford Bronco rev. | 46818 v1 [Published]
2022-11-30 14:02 UTC
IAG Performance
4/6
