1
General Installation
Installation
Standard gate dimensions
Speed Adjustment
Ensure that the gate posts are set vertical and that the closing gap not less than 25mm.
It is important to settle the mechanism. Allow at least 1 hour after installation before the first operation. The
gate should now be operated to check the speed.
If the gate operation does not meet the site requirements it can be adjusted
as below.
Turn both screws in a clockwise direction to close
off both valves. The gate will now not close or
open.
Turn both screws approx 1.5 to 1.75 turn in an
anti-clockwise direction. This should give an
even speed.
Fine adjustment can be made turning the screws
as shown.
DO NOT TURN SCREWS MORE THAN 3 TURNS
FROM THE CLOSED POSITION.
OIL LOSS MAY RESULT CAUSING THE
MECHANISM TO FAIL THUS INVALIDATING ALL
WARRANTIES.
CLOCKWISE
ANTI-CLOCKWISE
