4
Install 5/16-18 x .75 square head bolts (item B),
5/16 flat washer (item C), and 5/16-18 hex head
keps nuts (item D) to the monitor bracket(item 2) .
Do not tighten this hardware.
Install the top support brackets by
installing the square head bolts (item
B) into the milled slots in the front nut
channels of the upright. Gently slide
the monitor bracket (item 2) to the
desired height and tighten the hex
head keps nuts to hold them in place.
Do not tighten this hardware to more
than 10 foot lbs of torque. Doing so
will cause scoring to the aluminum of
the upright.
If your monitor has a 100MM
mounting hole pattern (about 3.94")
attach the adapter plate (item A) to
the pivot (item 1) using the #10 hex
nuts and washers (items E and F).
If the mounting hole pattern of your monitor is 75MM (about 2.95") skip the previous step. Place
the nylon washer over the shaft of the pivot, and fit the shaft into the bronze bushing in the monitor
bracket
NOTE:
Your monitor can be installed to the pivot assembly prior to or after installing the pivot assembly to
the monitor bracket.
QS-SMS FPD MOUNTING FRONT UPR MTD ASSY
Installation
