6
LAB TABLE FRAME ASSEMBLY FOR EPOXY OR TRESPA WORKSURFACES
Step 1:
Attach beam connector plates to the ends of the bench support beams using the 5/16-18 x .75 hex head bolts
and 1/4 flat washers supplied as shown.
NOTE:
DO NOT TIGHTEN THE HARDWARE.
Place the support beams with the attached connector plates, open side toward the center, on a smooth flat
surface being sure to protect them from damage by foreign objects. IAC recommends the use of packing type
blankets or clean cardboard.
Step 2:
Align the workbench pedestals over the ends of the support beams and lower them down over the beam
connector plates so that the plates are on the
inside
of the pedestal tubing. Tighten the beam connector
hardware on both sides.
Note:
The frame should be aligned on the flat surface to make sure all four corners have the pedestal and
beams flush against the flat surface
