System Setup > Event Settings
Revision: 180906
Veo16i User Manual
Page | 75
Alarm Sensor
<SYSTEM SETUP> - <EVENT> - <ALARM SENSOR>
Link Alarm Inputs (Sensors/Events) with video channels and Alarm Out (Control/Relay). Enable
notification options for each individual alarm input (sensor/event).
>
NAME: Assign a custom name to Alarm Input (Sensor). E.g. PIR NW Exit
>
OPERATION: Set to N/O (Normal Open) or N/C (Normal Close):
N/O
(Normally Open). Normally Open. Switches to Close when alarm occurs.
N/C
(Normal Close): Normally Close. Switches to Open when alarm occurs.
>
LINKED CAMERA: Link the Alarm Input (Sensor/Event) with one or more of the connected
cameras. By linking camera with an Alarm Input, you can activate Alarm video recording, display
linked camera in full screen when alarm event occurs and include snapshot image of the linked
camera in email/FTP notifications.
>
ALARM OUTPUT: Link the Alarm Input (Sensor/Event) with one or more of the connected Alarm
Out (Controls/Relays). By linking control with an Alarm Input, you can activate the connected
Alarm Out device when alarm event occurs.
>
PRESET: Link the Alarm Input (Sensor/Event) with
linked PTZ cameras. Every time the Alarm Input is activated, linked PTZ camera(s) will go to the
linked preset.
Enable one or more Alarm event notifications. Refer to
information on BUZZER, VIDEO POPUP, OSD POPUP, EMAIL and FTP notification
configurations (Optional).
>
BUZZER: Enable buzzer alarm notification for selected Alarm Input (sensor).
>
VIDEO POPUP: Enable video popup notification for selected Alarm Input (sensor).
NOTE:
If multiple events occur at the same time or the event is
channel, the video popup will display all
channels in the smallest suitable screen division
rather than in full screen mode. E.g. Two alarming video channels will be shown in a 2x2 screen
division.
>
OSD POPUP: Enable OSD popup notification for selected Alarm Input (sensor).
>
EMAIL: Enable email notification for selected Alarm Input (sensor).
