.
2.3 Location of the labels
The labels of 2.2.1 Read and Understand a manual, 2.2.2 Burn Hazard, and 2.2.3 Loud noise Hazard
shall be shown on the top of sound shield of the compressor.
The label of 2.2.4 Hazardous Voltage shall be shown on the cover of motor’s terminal box.
2.0 SAFETY
Please read the following safety notice carefully before operating the compressor.
2.1 General Notices
-
Understand fully this installation and operating manual before operation.
-
The other person except authorized operator should not operate the compressor.
-
When the compressor is not properly working, it should be stopped immediately.
-
I.VA.CO. shall have no liability for any accident and failure arising from no compliance with
instructions in this manual.
2.2 Warning labels and its explanation
Following warning labels are shown and attached on ICP series compressor.
2.2.1 Read and Understand a manual:
Read and understand operator
’
s manual before using this machine.
2.2.2 Burn Hazard:
Hot surface. Do not touch.
2.2.3 Loud noise Hazard
Loud noise hazard. Ear protection must be worn.
2.2.4 Hazardous Voltage:
Disconnect power before opening. Contact causes severe electrical shock
3.0 OPERATION
3.1 Start-up
Check rotation of the motor as described in paragraph 1.4 Power Requirements.
Fill the compressor with oil as described in paragraph 1.5 - Oil Filling
Run the compressor for a few minutes and then shut down. Check the
oil level again and make sure the oil level is 1/2 position of oil sight glass at stop status.
Add oil though oil fill port on the top, if necessary. Compressor oil should only be added when the
compressor is off
3.2 Stopping the compressor
To stop the compressor, turn off the power.