Driver Installation
27
3
3.2
Display Parameter Setting in Kernel
YMBAO100
supports HDMI output by default.
1.
If you use HDMI to display, run the command below.
/home/root/display_config/config_displag_mode.sh 1
2.
If you use LVDS 7
” to display, run the command below.
/home/root/display_config/config_displag_mode.sh 2
3.
If you use LVDS 15
” to display, run the command below.
/home/root/display_config/config_displag_mode.sh 3
4.
If you use LVDS 21.5” to display, run the command below.
/home/root/display_config/config_displag_mode.sh 4
Summary of Contents for YMBAO100
