Getting Started
Before using your i.VoicePRO (“headset”) for the first time, please ensure that
1. the headset is fully charged;
2. the fully charged headset must be paired and connected with a
Bluetooth
mobile
phone.
Charging Your Headset
Use only the supplied charger to charge the headset.
The headset comes with a built-in rechargeable battery. Prior to using the headset for
the first time, you are recommended to fully charge the battery.
4
USB Charging Socket
Status
Status Indicator
Audio
• Charging
• Red light
• Fully charged
• Blue light
• Low battery
• Flashing red light
• a short beep every 1 minute
• Out of battery
• The light goes off
♦
3 hours are required to fully charge the headset.
♦
Charging indication will be delayed for a few seconds if the headset has not been used
for a long time or the battery is drained.
5
Charging Your Headset (cont’d)
Pairing Your Headset with a
Bluetooth
Mobile Phone
1) Ensure the headset is off.
2) To activate the pairing mode, press and hold the headset’s MFB for 8 seconds without
releasing your finger until its status indicator flashes blue and red light alternately.
3) Activate your mobile phone’s
Bluetooth
, search
Bluetooth
devices, select “i.VoicePRO”
and enter the passcode “0000”. If your mobile phone supports
Bluetooth
v2.1 “Simple
Pairing” function, no passcode is required. When the pairing is completed, the headset’s
status indicator will flash blue light rapidly five times.
If the pairing cannot be completed within three minutes after the pairing mode has been
activated, the headset’s status indicator will flash purple rapidly five times and then turns
off. Repeat steps 1 to 3 to pair both devices again.
Pairing Your Headset with Two Mobile Phones (Multipoint)
i.VoicePRO supports a Multipoint function to allow simultaneous pairing of the
headset with two mobile phones.
1. Follow the pairing procedure as instructed in “Pairing Your Headset with a
Bluetooth
Mobile Phone” to pair the headset with the first mobile phone.
2. Repeat the pairing procedure for the second mobile phone.
3. On the first mobile phone’s menu, activate its
Bluetooth
connection with the
headset.
6
7
When you turn on your headset for the first time, the headset automatically enters the
pairing mode, i.e. the status indicator flashes blue and red alternately. This allows you
to immediately pair your headset and mobile phone.
Using Your Headset
Using Your Headset (cont'd)
Function
Button
Audio
Status Indicator
Power ON
Press and hold the
MFB
for 2
a short beep Flashing blue light 3
seconds
times
Power OFF
Press and hold the
MFB
for 2
a long beep
seconds
Say the voice tag as soon as you hear the short beep and you must have recorded the voice
tag into your mobile phone.
Function
Button
Audio
Status Indicator
Answer a call
Press the
MFB
once
Flashing blue light
End a call
Press the
MFB
once
Flashing blue light
Last No. Redial
Double click the
MFB
Flashing blue light
Call Reject
Press and hold the
Volume Key
a short beep Flashing blue light
for 2 seconds
Call Transfer
While speaking, press and hold
Flashing blue light
(headset to mobile phone) the
Volume Key
for 2 seconds
Call Transfer
While speaking, press
MFB
once
Flashing blue light
(mobile phone to headset)
Adjust Volume
Press the
Volume Key
once to
a short beep Flashing blue light
increase / decrease by 1 step
(Total 6 levels)
Voice Dialing
Press the
MFB
once
a short beep Flashing blue light
Red light for two seconds
and then the light goes off
