IMPORTANT
•
The mask area may move out of alignment if the setting for “Image rotation” of the [Basic] tab is changed
after the mask area has been configured.
Make sure to check the mask area after changing the “Image capture mode” setting.
•
The mask area may move out of alignment when “Extra optical zoom” is configured. Make sure to
check the mask area after changing the setting.
Note
•
When the [Reset] button is clicked, masking for all the masked areas will be canceled.
3.6.4.3 Adjust the angular field of view using the Extra optical zoom
function
Click the [Setup>>] button of “Extra zoom” on the [Image quality] tab of the “Image/Audio” page.
(
®
“3.6.4.1 Configure the settings relating to image quality (“Image adjust” setup menu)”)
It is possible to adjust the angular field of view using the extra zoom function.
•
: Click this button to adjust the zoom ratio to the “Wide” side.
•
: Click this button to set the zoom ratio to x1.0.
•
: Click this button to adjust the zoom ratio to the “Tele” side.
•
: Click these buttons to adjust the horizontal/vertical position of the image after zooming.
Note
•
For information about the maximum zoom ratio, refer to the Important Information.
IMPORTANT
•
The positions will move out of alignment if extra zoom settings are configured when the mask area
(
®
“3.6.4.2 Set mask areas”), privacy zone (
®
“3.6.4.4 Configure the settings relating to the privacy
zone (“Privacy zone” setup menu)”), VMD area (
®
“3.8.3 Configure the VMD settings [VMD area]”),
Operating Instructions
97
3 Detailed Settings
