3.
Click the [Set] button after completing the settings.
IMPORTANT
•
The setting will not be applied unless the [Set] button is clicked.
4.
To invalidate the VMD area, click the [Set] button after selecting “Off” for “Status” of the VMD area to be
invalidated.
→
The outline of the invalidated VMD area will turn to a dotted line. When the VMD area is invalidated,
no alarm will occur even when a motion can be recognized in the area.
5.
To delete the VMD area, click the [Delete] button corresponding to the area to be deleted.
→
The outline of the respective VMD area will disappear.
6.
Click the [Set] button.
→
The edited settings will be applied.
3.8.5 Configure the SCD settings [SCD area]
Click the [SCD area] tab on the “Alarm” page. (
®
For menu display and how to operate, refer to “3.2.1 How to
display the setup menu”, “3.2.2 How to operate the setup menu”)
By configuring SCD (scene change detection) setting, it is possible to issue an alarm when a camera is covered
with something or the camera direction is changed to shoot a different subject.
The detection area using the SCD function can be set on this section. Up to 1 area can be set. When a shooting
subject is changed in the set area, it will issue an alarm.
IMPORTANT
•
Since it takes time for necessary learning in the following period, the SCD will not function for a while.
–
Right after the SCD is set
–
After the power of this product is turned on
–
After a scene change is detected
•
The alarm occurrence indication button (
®
“1.1.2 About the “Live” page”) will be displayed when scene
change is detected by the SCD function.
•
The alarm occurrence indication button will be displayed at a VMD alarm occurrence or when receiving
a command alarm as well.
•
After configuring the SCD area, the SCD area may move out of alignment when “Image capture
mode” of the [Image] tab is changed. Make sure to check the SCD area after changing the “Image
capture mode” setting.
•
In the following cases, scene change may not be detected.
–
Only a part of the shooting area is covered or the covered object can be seen.
–
Subjects look alike each other before and after the camera direction has been changed.
–
In the area where the privacy zone is set.
•
The SCD function is not the dedicated function to prevent thefts, fires, etc.
We are not responsible for any accidents or damages that may occur.
•
When “Detection time” of “SCD area” is shorter than “Dwell time” of “Day & Night(IR)”, a scene change
detection (SCD) may be activated at the time when an image is switched to BW. It can be improved
by setting “Dwell time” of “Day & Night(IR)” shorter than “Detection time” of “SCD area”.
•
When the image color is close to monochrome, detection of SCD alarms may become difficult. When
no alarms is detected, increase “Detection sensitivity” or set smaller “Detection area”.
[Area]
Set by selecting an SCD area on the screen.
[All areas]
Set the entire image in the SCD area.
114
Operating Instructions
3 Detailed Settings
