24
20. Pixel compensation [PIX OFF]
Flaws of pixel in the displayed camera image are corrected. Up to 16 points can be corrected.
Follow the procedure below.
**PIX OFF**
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
1
DEL
000 000
"SPECIAL SETUP" screen
“PIX OFF” screen
Pixel compensation positioning screen
RET TOP END
**SPECIAL SETUP**
CHROMA GAIN ....I..160
AP GAIN ..I.... 20
PEDESTAL ...I... 32
- +
PIX OFF
DISPLAY ALARM
CAMERA RESET PUSH SET
SER.NO. XXXXXXXX
COMMUNICATION COAX
RET TOP END
Step 1
Move the cursor to “PIX OFF” and press the [SET] button.
→
The “PIX OFF” screen appears.
Step 2
Select a number (1 to 16) with which a pixel compensation point is registered and press the [SET] button.
→
The pixel compensation positioning screen appears.
Step 3
Press the [UP], [DOWN], [RIGHT] and [LEFT] buttons to move the crosshair cursor to the center of the flaw to be corrected and press
the [SET] button.
→
The flaw is corrected and the pixel compensation point is registered. The “PIX OFF” screen appears again. An asterisk “*” is
attached at the right side of the number when registration is completed. The coordinate is expressed in figures.
Note:
• To clear the registered pixel compensation point, move the cursor to “1” of the right of “DEL”, use the [RIGHT] and [LEFT] but-
tons to select the number with which the target pixel compensation point is registered and press the [SET] button. The registered
pixel compensation point is cleared, and an asterisk “*” at the right side of the number disappears.
21. Communication setting [COMMUNICATION]
The required communication configuration is performed to use this unit integrated into the system with a receiver.
COAX (RCV):
When using our receiver.
COAX
(default)
:
When not using any receiver.
22. Default resetting [CAMERA RESET]
The settings in the setup menu are restored to the default settings.
The default settings are restored by moving the cursor to “PUSH SET” of “CAMERA RESET” and holding down the [RIGHT], [LEFT] and [SET]
buttons for more than 2 seconds simultaneously.
Note:
• The data of the back focus setting (
☞
page 21) and registered pixel compensation points is not cleared.
23. Serial number viewing [SER.NO.]
Displays the serial number of this product.
