49
Configure the advanced settings for recording and events [Advanced setup]
Configure the special settings related to recording on this tab. Set up the recording mode, alarm disarm
duration and TCP alarm port number (the port number for incoming site alarm).
[Recording mode]
Determine whether or not to stop all recording
actions. Set to "Off", primarily to stop access to the
HDD before turning off the power.
On: Performs recording.
Off: Stops all recording actions.
Default:
On
Important:
• If "Off" is selected, be sure to return the setting to
"On" when resuming operation.
[Alarm disarm duration]
Set the period to suspend event actions for the case
that the same kind of event (terminal alarm, camera
site alarm, command alarm) occurs repeatedly at the
same camera.
2 s/ 3 s/ 5 s/ 10 s
Default:
2 s
[TCP alarm port number]
Specify the number of the port to be used for
receiving site alarm.
Default:
1818
Note:
• Enter the port number in five digits, right aligned.
(Example: When the port number is 80, enter
"00080".) The leading zeros are omitted here.
• The following numbers, the HTTP port number, the
HTTPS port number and the port number of the
port forwarding are unavailable.
20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110,
123, 161, 162, 443, 546, 547, 995, 10001, 10002,
10003, 10004, 10005, 10006, 10007,
50000~50255
[Extension software alarm]
Set the extension software alarm name and message ID.
The AI-VMD and AI Occupancy Detection features
must have been configured on the target camera to
use the enhanced software alarms 1-8.
[Name]
Enter the names of the extension software alarms 1 to
16 from the on-screen keyboard (up to 16 characters).
Note:
• The alarm log, event information display, event
type (
☞
☞
are displayed with the set name.
• If the setting is saved in blank, it will return to the
default name.
[Message ID]
Select alarm message ID to be received as extension
software alarms 1 to 16 in decimal number (000 to
255).
Note:
• When the message ID is set, the set alarm name
is displayed in the event type (
☞
page 136) and
REC event (
☞
page 171).
[Setup via recorder's main monitor]
