CABLINE-CBL PLUG Assembly Manual
Document No.
ASM-09002
17
/
18
Confidential C
⑤
SHELL A
と
SHELLB
を半田コテにて半田付けする。 （
Fig.8
◆部）
半田コテの条件は、
5
頁参照。コテ先形状は下記参照。
半田量は半田はみ出しを注意し、適量を付ける。
SHELL A and SHELL B are soldered by the soldering iron. (Fig.8
◆
point)
Conditions of Soldering iron refer to sheet 5. Recommended tip shape is as shown following.
Put the appropriate amount of solder, notice the solder protrudes. (See below photo.)
Recommended tip shape (UNIX JBC 2245-036)
Fig.8 Soldering of SHELL A and SHELL B
OK NG
※注意
SHELL A
と
SHELL B
が半田付けされていない場合は、ラッチバー外れの原因となります。
※
Attention
There is possibilities to cause Latch bar dropping out from the connector, if Shell A and Shell B are not soldered.
OK
◆
Point
Solder protrudes area
OK
NG
Latch bar
外れ
NG
NG: Latch bar is dropping out.
NG
