INSTALLATION MANUAL FOR THE EMS I-MO 540 SERIES APPLIANCE
Version
1.2
ELECTRONIC MEDIA SERVICES LIMITED
PASSFIELD BUSINESS CENTRE, LYNCHBOROUGH ROAD, LIPHOOK, HAMPSHIRE, GU30 7SB, UK
Tel:
01428 751655 |
Fax:
01428 751654 |
E-mail:
Page
46
of
58
br0dhcpendip="192.168.0.199"
dhcpdnsserver1="10.0.0.16"
# Use head office private DNS servers
dhcpdnsserver2="10.0.0.17"
dhcpdnsdomain="mydomain.com"
# Set default DHCP domain
eth0enabled="yes"
# Enable ports 0–4 and add to bridge interface
eth0bridging="yes"
eth1enabled="yes"
eth1bridging="yes"
eth2enabled="yes"
eth2bridging="yes"
eth3enabled="yes"
eth3bridging="yes"
eth4enabled="yes"
eth4bridging="yes"
wlan0enabled="yes"
# Enable WiFi and add to bridge interface
wlan0bridging="yes"
wlan0wifissid="imo"
# Set SSID
wlan0wifiwpakey="12345678"
# Set WPA key – must be 8-63 characters long
wlan0wifichannel="manual"
# Only manual selection currently supported
wlan0wifichannelvalue="6"
# Set WiFi Channel 1-13, 1/6/11 preferred
wlan0wifirate="manual"
# Set maximum bandwidth
wlan0wifiratevalue="24"
wlan0wifi80211mode=“g”
# Set WiFi 802.11b/g mode
eth5enabled="yes"
# Configure port 5 as WAN port
eth5bridging="no"
eth5firewallzone="external"
# Place in external zone
eth5ip="195.74.68.4/28"
# Set IP address/netmask
[failover]
enabled="yes"
# Enable failover
routerrefresh="10"
# The failover router will be updated
# every “routerrefresh” seconds
routerperiod="31"
# If active link is unavailable for
# “routerperiod” seconds it will be
# marked unavailable and next failover
# link will become active.
tunnel="imo"
# Name of tunnel to create when a
# failover link becomes active
link0device="eth5"
# Interface or link name for primary link
link1device="mob0"
# Interface or link name for seconday link
[tunneling]
enabled="yes"
# Enable tunneling
protocolversion="2"
# i-MO version 2 protocol (default protocol)
encrypt="yes"
# Encrypt tunnels by default
compress="no"
# Do not compress by default
tunnel0name="imo"
# Set tunnel name
tunnel0firewallzone="internal" # Set to trusted firewall zone
tunnel0ip="10.250.0.10"
# IP address for tunnel
tunnel0key="imokey"
# Shared secret
tunnel0bonding="no"
# Channel bonding off
# this tunnel is only used for failover
tunnel0networks="default"
# Subnets to route over the tunnel
# “default” shows this is the default route