Powers in watts r.m.s per channel using 1 kHz tone.
The peak powers are short term maximum peak powers.
All other power measurements are long term continuous tone.
FREQUENCY RESPONSE: 3.5 Hz - 22 kHz + Odb - 3db
INPUT SENSITIVITY: OdBm 0.775v
DAMPING FACTOR > 100 @ 100Hz
DISTORTION: 0.05% @ 1Khz
INPUT IMPEDANCE: 35Kohms
NOISE LEVEL: -95dBm
CONTROLS FRONT: Power On / Off Green Neon rocker switch.
Channels 1, 2, 3, 4. rotary volume controls, & associated
channel clip indicators, bridge mode indicators, fan run
indicator, 2 fault indicators.
CONTROLS REAR : 2 Bridge mode switches, 2 mono / stereo mode switches.
PROTECTION: Individual channel protection disconnects speakers
when 800mV, DC is present on output. Fuses also
provide short circuit protection.
THERMAL: Automatic shutdown @ 150 deg C ( Auto reset)
COOLING: 2 fans speed change switched on at 50 deg C.
INPUTS: 1 IEC Mains socket for A/C input
8 stereo input/link jacks balanced line, 2 per ch
OUTPUTS: 4 XLR male sockets 1 per channel
MAINS FUSE: 12.5A HRC 20mm.
POWER FUSES: 4 x 10A 20mm. (internal)
SIZE: 483 X 90 X 290. (19" x 3.5" x 11+" )
WEIGHT: 17Kg ( 38lbs. )
MAINS SUPPLY: 240/220v or 120/110v. A.C. 50/60 Hz
1.4KVA @ full power.
6.
FAULTS AND THEIR LIKELY CAUSES
Although the greatest care has been taken in the manufacture of the power amplifier, the
possibility remains that faults could occur during use or difficulties could be experienced
during initial installation.
The cause, however, will rarely be found to be internal to the amplifier. Below is a list of
symptoms and possible causes. Some of the suggested causes may appear obvious but
they can be easily overlooked.
Under no circumstances should you open the amplifier ; this is dangerous, will expose
high voltages, and will invalidate all rights under the guarantee..
