Hyundai WSP 2080 r WIND, Instruction Manual

Page: 66 / 96

EN - 66
SET UP GUIDE
Before placing and installing all components of the weather station at there final destination,
please set up the weather station with all parts being nearby for testing the correct function.
SETTING UP THE BASE STATION AND TRANSMITTER
Insert two pieces of LR6 (AA size) batteries into the transmitter, the LED located in the middle
front case of transmitter will be turned on for 4 seconds, then it will be off and start to work nor -
mally. The transmitter will make a data transmission and then start radio controlled time recep -
tion routine. If time signal can be detected correctly, the LED will start to flash 5 times, and then
the LED will be on for 20s, indicating time signal has been found correctly. When time signal is
bad and reception is not possible, the transmitter will terminate radio controlled time reception
within one minute and resume normal mode. When there is a data transmission happened, the
LED will be on for 20ms. During radio controlled time reception period, there is no transmission
and normal transmission will only resume after time reception routine is complete. The longest
time for radio controlled time reception is 5 minutes.
After inserting the batteries into the Weather Station, all LCD segments will be turned on for
a few seconds, all possible display segments are turned on for checking.
After this, the weather station will make initial measurement and start to register the transmitter
(the radio reception icon will be turned on). Do not press any key before outdoor sensor data
received, otherwise the outdoor sensor learning mode will be terminated. When outdoor trans -
mitter has been registered, the base station will automatically switch to the normal display mode
from which all further settings can be performed by the user.
If no RCC signal is detected in the initial setup, the transmitter will try once every hour to get
an RCC signal until a signal is received. Once the transmitter receives the RCC signal it will
transmit the signal to the monitor. On the monitor the RCC icon will be displayed, if the monitor
doesn’t receive the RCC signal or loses the signal the RCC icon will not be display.
Register transmitter
If no outdoor weather data is displayed or the signal to the sensors is lost during setting up,
mounting, changing of batteries to the sensor or plugging or unplugging cables, simply press
and hold the DOWN/- key for 4 seconds and a short beep will sound to synchronize the base
station to sensors. Without being synchronized, weather data will not be received.
Note:
The best condition for reception is at night, between midnight and 6:00am – when there is less
atmospheric interference.
Note:
Commonly the radio communication between receiver and transmitter in the open field can
reach a distance of up to 330 feet providing that there are no interfering obstacles such as build -
ings, trees, vehicles, high voltage lines, etc.
Radio interferences such as PC screens, radios or TV sets can, in bad cases, entirely cut off
radio communication. Please take this into consideration when choosing standing or mounting
locations.