Hyundai WS2094 INTERNET, Instruction Manual

Page: 52 / 72

ENG - 52
INSTALLATION
SETTING UP THE MAIN UNIT (RECEIVER)
BATTERy INSTALLATION:
Battery installation: Slide to open the battery door, install 6 pieces of AA batteries according to
the polarity indicated and close the battery door.
LOCAL WEATHER FORECAST & PRESSURE SETTING
A pressure sensor is built in the main unit to provide local pressure reading & local weather
forecast backup. After battery installation, the main unit will enter pressure setting mode in the
following sequence. Pressure unit (mb / hPa or in Hg) > Current sea level pressure > Current
local weather condition > Exit The corresponding icon will flash. Press [▲] or [▼] to select,
press [BARO] to confirm each setting.
NOTE:
Please check the current sea level pressure reading of your location from weather web site
Please select current weather condition of your location between sunny, partly cloudy, cloudy,
rainy or stormy.
You may also enter the local weather forecast & pressure setting any time by holding the
[BARO] button for 3 seconds. (Details also refer to the “BAROMETRIC PRESSURE & LOCAL
WEATHER FORECAST” section).
SETTING UP THE REMOTE THERMO SENSOR
BATTERy INSTALLATION
Loosen the screws on the battery door with a small screw driver, insert 2 pieces of AAA batte -
ries according to the polarity indicated. (Replace the cover and tighten the screws after the RF
setting below).
ESTABLISH RF CONNECTION WITH MAIN UINIT
Place the main unit away from metal & source of interference such as mobile phones, appli -
ances, TV etc.
For the first installation, turn on the main unit and then the remote sensor. Set Channel 1 for
the first remote sensor. Set channel 2 and channel 3 for the 2nd and 3rd sensor
Hold [CHANNEL/SEARCH] button on main unit until a beep is sound to search for remote
sensor. The corresponding channel number on the display will flash indicating it is in the sear -
ching mode.
Press the [Tx] button inside the battery compartment of remote sensor to transmit RF signal
When RF connection is established, the respective temperature of the selected channel will
appear on the main unit.
Replace the cover and tighten the screws on the remote sensor.
-
-
-
-
-
-
-
-
-