ENG - 28
PRESS “CHANNEL” button
PRESS “CHANNEL” button
PRESS “CHANNEL” button
display the three
channels
alternatively
• When viewing the record on CHANNEL 1 or 2, or 3, hold “CHANNEL” button (B8) for 3
seconds to cancel the record on this channel manually, and receive the transmission from
channels automatically again.
(2) Celsius / Fahrenheit
• Press “-” button (B2) to select Indoor/Outdoor Temperature in Celsius mode or Fahrenheit
mode.
• If the temperature is out of the measurable range, LL.L (beyond the minimum temperature)
or HH.H (beyond the maximum temperature) will be shown on the LCD.
(3) Maximum / Minimum Temperature & Indoor Humidity Recording Function:
• Press “MAX/MIN” button (B1) to show the maximum recorded Indoor / Outdoor Temperature
and Indoor Humidity. “MAX” is shown on the LCD.
• Press “MAX/MIN” button (B1) again to show the minimum recorded Indoor/Outdoor
Temperature and Indoor Humidity. “MIN” is shown on the LCD.
Note
:
If you want to clear the recorded maximum and minimum reading, you will have
to RESET and then re-install the unit.
(4) The use of 1.5 m cord Temperature Probe:
• Insert the probe plug (D7) to the jack on the right hand side of the thermo sensor unit.
• Put the cable outside and leave the thermo sensor unit in indoor area to avoid freezing
up the battery when the outdoor temperature is below -20 °C.
• Always use the temperature probe to sense the temperature when the temperature
is between the following range: -50 °C ~ 0 °C and +50 °C ~ + 70 °C.
7. TIME AND ALARM SETTING
7.1 Radio Controlled Clock:
• After batteries inserted and main unit finishes receiving the transmissions from outdoor
thermo sensor, the clock automatically starts to scan the DCF time signal.
Radio Control Icon “
” (A7) flashes on the LCD.
(A7) flashes,
Indicating now is receiving
DCF signal
(A7) turns on,
Indicating signal received
successfully
(A7) disappear,
Indicating signal reception
failed
• The clock automatically scans the time signal at 3.00 a.m. every day to maintain accurate
timing. If reception fail, scanning stops (“
” on LCD disappear).
• The clock can be set to scan the time signal manually by holding “-”button (B2) for 3 sec.
• Stop scanning by holding “-” button (B2) for 3 seconds.
• "DST” shown on the LCD if it is in Daylight Saving Time Mode.
Note
:
Buttons will not function while scanning for DCF time signal unless they are well received
or stopped manually.
