Hyundai VK 750, Instruction Manual, Page: 26 / 41

ENG
26 / 34
Turn the kettle on by pressing button A5 , points next to corresponding temperatures will
gradually light up on the display, while showing the current temperature until the water reaches
the boiling point. Then the heating will stop and the appliance will turn off “automatically” (there
will be a sound signal = 3 beeps. Before reaching the set water temperature, the appliance can
be switched off “manually”, namely by repeated pressing of the A5 button. Always use fresh
drinking water for heating.
ATTENTION
– The control on the stand does not work without the kettle on it.
– During heating, the increasing water temperature is optically signalled by the changing colour
of the water gauge lighting (i.e. 0-59 °C=green / 60-69 °C= yellow / 70-79 °C= blue / 80-89 °C=
violet, and / 90-100 °C= red).
– When heating water, the lid must be closed, otherwise the kettle will not turn OFF.
– When water boils, the steam passes through the steam channel and then switches off the
kettle. To pour water, lift the kettle from the power base and pour. When pouring out the water
incline the kettle slightly and gradually. Do not forget that hot water is inside.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up to maximum,
water can flow out from the electric kettle in the bottom part of the kettle. This does not affect
safety or other functions and it does not mean any failure of the electric kettle. In the case
of tilting the electric kettle with hot water there is a risk of scalding. Therefore do not tilt the
electric kettle.
– If unusual symbols appear on the display, disconnect the appliance from the mains power
supply and then reconnect it.
Setting the Water Temperature with the Temperature Sustaining Function
If you want to heat up water to a certain preset temperature and additionally heat up the
water to that temperature at the same time, press button
A7
until the required temperature
is shown on the display. The value on the display and the point will flash 5 times, the lighting
of the respective point displays the set temperature. After turning on the heating by pressing
button
A5
, point
A9
will be lit intermittently and the current water temperature will be shown on
the display. After reaching the temperature, there will be one sound signal and the point will
continue to shine intermittently. The kettle will switch into the temperature sustaining mode. The
condition is signalled by the intermittent light of the set temperature point until shutdown. The
kettle maintains the set temperature for 60 minutes, then it beeps and turns off.
CAUTION
– Keep enough water on the minimum water level (0.5 L).
– During the keep warm program, the water temperature will stay in the setting degree with
tol/-5 °C.
ATTENTION
– Unless you push button A5 while the set value is flashing on the display, the kettle
switches into the basic mode of displaying the current water temperature and it is
necessary to repeat the setting process.
– If the water in the kettle is warmer than the temperature sustaining setting, the required
temperature point is flashing. After cooling down to the required temperature, the kettle keeps
maintaining the set temperature.
– Lifting the kettle off the stand cancels all the set functions.
Setting the Water Temperature
Using buttons A6 , you can set the desired water heating temperature. The temperature and
time of heating depend on the quantity of water and the initial water temperature. For correct
water temperature setting, obey the producers’ instructions stated on food packaging (e.g. tea,
coffee, instant drinks, soups, etc.).