EN - 22
Product Specifications(fOR INDOORS ONLy)
Rechargeable Handheld Vacuum Cleaner
Model No:VH01W-08K B
Motor
4.8Volt DC
Switch
On/Off
Adapter(Charger)Rating
230-240V 50Hz,AC only
Adapter(Charger)Voltage
9V DC 200mA
Charging Rate
12 – 16 hours
Battery Pack
1.2-Volt X 4 Ni-Mh Cells
OPERATION
BEfORE USE
1. This cordless vacuum is powered by rechargeable Ni-Mh batteries. Before using the vacu
-
um, charge the vacuum cleaner for a minimum of 12 hours. Extreme weather (too hot or too
cold ) is dangerous and not good for the battery do not charge the battery in temperatures
above 37 C or below 0 C.
NOTE: Ensure that the On/Off switch on the hand vac is in the off position before
charging.
2. Keep away from heat sources. Garages, workshops and indoor areas are the ideal
Storage / Charging places for the vacuum.
3. Do not store the vacuum in areas with high temperature, or in the trunk of your car,
while it is parked underneath direct hot sunshine.
4. The normal full charging time for this vacuum is 12 hours. The vacuum cleaner will
run for maximum operational time only if it has been fully charged. To fully charge the unit,
run the vacuum cleaner until it stops, then fully recharge the battery.
IMPORTANCE:
To maintain peak performance of your cordless hand vac, it is recommen
-
ded that the unit be fully discharged, then completely re-charged at least once a month.
CHARGING yOUR VACUUM CLEANER
1. Place the vacuum near an electrical power outlet(220-240V/50Hz) and plug in the charger.
2. Put the unit in the charge base, then connect charger with power. The charging indicator
light will shine blue to indicate that the vacuum cleaner is properly connected to the charger
and being charged.
3. Always return the handle vacuum to the charger immediately after use so that it will be
ready and fully charged for it‘s next use.
OPERATE:
1. Lift and remove the vacuum from the Charge Base and push down the Switch Button.
The vacuum cleaner will start to work.
2. The vacuum cleaner will be switched off when you push down the Switch Button again.
3. To pick up the solids in any direction until the area is clean.
4. If you like, you may use the crevice tool ,upholstery nozzle to fit into the mouth of the Dust Cup.
5. Empty the Dust Container before doing any more vacuuming and cleaning it before putting
it away.
6. Replace the cleaner on the Charge Base .the Ring Light will come on to indicate that the
cleaner is being charged.
THIS VACUUM CLEANER IS INTENDED fOR NORMAL HOUSEHOLD USE ONLy
