ALL STYLES:
15.
Route white connector from main harness through 25mm (1") hole on back side of console.
16.
Plug white connector into UIB-Door assembly. Make sure connector locks in place.
17.
Reconnect negative (-) battery terminal.
18.
Turn the ignition to ON position. The operating buttons on the UIB assembly will illuminate. Allow 5 seconds for
the system to self-check.
19.
Push the phone button to activate the system. The blue center bar will illuminate and "BlueConnect Ready"
will be heard. BlueConnect® is now ready for the pairing process and use.
20.
Reconnect all wire harness connectors to back of overhead console. Push overhead console into opening and
replace screws.
21.
Use plastic trim removal tool to close sunglass bin door until clip locks into place. Ensure door is securely locked
into place (drilled 7/32" holes).
INSTALLATION PROCEDURE
Volume up and
down buttons
Phone button
19
20
16
21
Page 15 of 17
