EN - 50
OPERATING INSTRUCTIONS
RADIO OPERATION
1. To turn on the system ‘ON’. press
POWER
button. The backlight remains ‘On’.
2. Set the Function selector(AM/FM/PH/CD/USB) to AM or FM position.
3. Rotate the
TUNING
control to tune the desired radio station. If you tune to an
FM
stereo
station, the
FM ST
. indicator will light and reception will be in stereo. If you tune to a weaker
FM
station, the reception will automatically switch to mono.
4. Adjust the
VOLUME
control to a desired level.
5. When you finished listening. press
POWER
button to turn the system off.
ANTENNA INFORMATION
PO
CD
FM
TA
AM
OF F
V OL UME
FM ST .
MW
FM
LINE OUT
The
AM
antenna is inside the cabinet. If
AM reception is unsatisfactory try
repositioning the cabinet slightly until the
internal antenna is picking up the
strongest signal.
The
FM
wire antenna is located on the
back cabinet. If necessary adjust the
position and direction of this antenna
until you find the position that provides
the best reception.
CD OPERATION
NOTE:
You may level hold the PLAY/PAUSE button to change the playing mode between CD
and USB.
1. Press POWER to turn on the appliance.
2. Rotate the VOLUME control clockwise and set the volume to a low level.
3. Set the Function selector(AM/FM/PH/CD/USB/TAPE) to the CD/USB position.
4. Press the OPEN/CLOSE button to open the CD drawer.’NOd’ will be shown on the disc if
has no disc in the CD drawer
5. Place your disc(MP3 is compatible) in the CD drawer with the label side facing up.
6. Press the OPEN/CLOSE button again to close the CD drawer. The disc will spin for a few
seconds while the player is reading the disc, then the disc stops spinning and start to play
the first track on the disc. The playing track number, Cd and the folder name will be shown
on the screen 5 seconds in turn during the playback. For example: ‘001‘’Cd’’F01‘.
7. Press the SKIP REV.(DN/FR) or SKIP FWD.(DN/FF) button to choose play the desired track.
8. Adjust the VOLUME to the desired level.
9. Playback will continue until the end of this disc. You may stop at any time by pressing the
STOP button.
