ENG
ENG - 47
•
Pull out the plug from the socket;
•
Remove all stored food, wrap it in several layers of newspaper and put it in a cool place;
•
Keep the door open, and placing a basin underneath of the appliance to collect the defrost water;
•
When defrosting is completed, dry the interior thoroughly
•
Replace the plug in the power socket to run the appliance again.
TROUBLESHOOTING
CAUTION!
Before troubleshooting, disconnect the power supply. Only a qualified
electrician of competent person must do the troubleshooting that is not in this manual.
IMPORTANT!
There are some sounds during normal use (compressor, refrigerant
circulation). These sounds are not a reason for complaint!
Problem
Possible cause
Solution
Appliance does not work
Temperature regulation knob is
set at number “0”.
Set the knob at other number
to switch on the appliance.
Mains plug is not plugged in or
is loose.
Insert mains plug.
Fuse has blown or is defective
(circuit breaker is OFF).
Check fuse, replace if
necessary (switch ON the
circuit breaker).
Socket is defective
Mains malfunctions are to be
corrected by an electrician.
The food is too warm.
Temperature is not properly
adjusted.
Please look in the initial
Temperature Setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature
regulation to a colder setting
temporarily.
The appliance is near a heat
source.
Please look in the installation
location section.
Appliance cools too much
Temperature is set too cold.
Turn the temperature
regulation knob to a warmer
setting temporarily.
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the
wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
If necessary, carefully bend the
component out of the way.
Side panel is hot
Condenser is inside the panel.
It’s normal.
If the malfunction shows again, contact the Service Center.
