Hyundai RSB 085 WW 8S, Instruction Manual

Page: 13 / 28

EN
ENG - 13
4.Changing the reversible door
This refrigerator has been built with the door hinges on the right. If you wish to change the ope -
ning direction, follow the instruction below:
1. Remove the upper hinge cover (6) first.
2. Remove the two screws(1) that hold the upper hinge(5) (right side) to the frame. Take away
the upper hinge(5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws(8) that hold the lower hinge(2) and make sure to remove the lower
hinge(2).
5. Remove the left front leg(4) and transfer it to the right side.
6. Remove the hole cover plate to the right side.
7. Before placing this lower hinge(2), remove the bolt-pin(9) and reverse the direction of the
lower hinge(2). Then install the lower hinge(2) onto the left side of the lower frame with 2
screws (8).
8. Insert the bolt-pin(9) to the lower hinge(2).
9. Set the door to its place making sure the door seat at the lower hinge (2).
10. While holding the door in the closed position secure the upper hinge (5) in the top frame of
left side with 2 screws(1). Please remember that do not tighten the 2 screws(1) until the top
of the door is levelled with the counter top.
11. Install the upper hinge cover (6) on the upper hinge.
FIGURE1 FIGURE2
FIGURE1 - REPRESENTS POSITION OF COMPONENTS PRIOR TO DOR REVERSAL.
FIGURE2 - REPRESENTS POSITION OF COMPONENTS AFTER DOR REVERSAL.