Hyundai IND 122, Instruction Manual

Page: 23 / 44

ENG
ENG - 23
HEAT
• In this mode, the user can adjust the power output of the unit.
• This power output then remains the same. The Power is adjustable from 1 to 10, where 10 is
the full power. This set up is especially usefull for fast water boiling – adjust to level 10.
• The pre-set power stage „5“ is selected and the device turns on (Power stages: 1, 2, 3, 4, 5,
6, 7, 8, 9, 10). With the +/- keys, you can change the settings at any time, ranging from 1-10.
Control light POWER (P11) lights.
Note:
For grades 1 and 2 is a cyclical switching to achieve a lower performance. Specified performance
is the average value.
TEMP
The temperature sensor, located underneath the glass-ceramic plate, monitors the bottom
temperature of the cookware. The user selects required temperature and the thermostat compares
the selected temperature with the temperature of the bottom of the coockware. When the selected
temperature is reached, the power will be disconnected. When the actual temperature of the bottom
of the coockware is lower then the selected temperature, the power will come ON again. This mode
keeps the selected temperature in a thermal range (+-20°C). This mode is in fact somewhat more
comfortable and economic.
The pre-set temperature stage „120 °C“ is selected and the device turns on
(Temperature stages: 60, 80, 100, 120, 140, 160, 180, 200, 220 and 240°C).
With the +/- keys, you can change the settings at any time, ranging from 60 – 240 °C.
Control light “TEMP“ (P8) lights.
TIMER FUNCTION:
After having selected the operating mode (power stage or temperature stage), press the “Timer” key.
The cipher “0” appears on the display and the LED-display MIN (P9) next to the display appears.
By using the +/- keys you will be able to select the operating time in increasing 5 minutes (up to
180 minutes maximum), and reducing 1 minute. 5 sec after setting the value the TIMER will start
and time will be countdowned in one minute intervals. Control lights MIN and POWER/TEPM will
lights for all timer interval. Once the time is up, you will hear an acoustic signal and the device
automatically enters standby mode.
AUTOMATIC TURN OFF WHEN LIFTING AWAY THE DISH
When the cooking dish is lifted away from the cooking surface, the unit will TURN itself OFF. If the
dish is returned back on the surface within 15 sec, the cooking process will resume with the pre-
lifting settings. If the dish is NOT returned back within 15 sec, the unit will TURN OFF completelly.
WARNING
: Once the cooking or warming process is finished, disconnect the mains plug from the
outlet!
MAINTENANCE AND CLEAN
-
Clean the appliance after each use. Disconnect the plug and wait until the unit cooled off. Do
not use fuel, paint thinner, a brush or polishing powder to clean the induction cooker.
-
Wipe the unit using a dish washing agent and a damp cloth. Use a vacuum cleaner to remove
dirt from the air supply and exhaust vent.
-
Wipe off the ceramic field with a damp cloth or use a mild, non-abrasive soap solution. Wipe off
the casing and the operating panel with a soft cloth or a mild detergent.
-
Prevent water from running over the unit (if water gets inside the unit, the cooker may malfunction).