–
Never use the vacuum cleaner nor touch the adaptor with wet hands or feet!
– Do not vacuum water, liquid or aggressive liquid!
– Do not vacuum sharp objects (e.g.
glass, shatter
), hot, flammable, explosive items
(e.g.
ash, hot cigarette butts, gasoline, thinners and aerosol vapours
) or greases
(e.g.
fats, oils
), caustic agents (e.g.
acids, solvents
). Vacuuming these objects may lead
to damage of the dust filters or the vacuum cleaner.
– Pores of the micro filters may be clogged when vacuuming very fine dust. Thus, air
permeability will be reduced and the suction performance will drop. In this case, micro–
filters have to be cleaned before the container is full. Do not use the vacuum cleaner to
vacuum dirt produced during/after construction such as
plasterboard dust, fine sand,
cement, dust from construction, parts of plaster
etc. If this dirt / loose construction
materials / loose construction materials into the aggregate, it poses a danger of damage.
The warranty repair does not cover this.
– Install the holder, the vacuum cleaner and the appliance within sufficient distance from
flammable objects (e.g.
curtains, drapes, wood, etc.
), heat sources (e.g.
oven, stove,
etc.
) and wet surfaces (e.g.
sinks, wash
–
basins etc.
).
–
If the adaptor of the appliance is corrupted, it has to be replaced
by the manufacturer, its service technician or a similarly qualified
person so as to prevent dangerous situations.
–
WARNING
: To charge the battery, use only the network adapter
supplied with this appliance.
–
To power the appliance, only apply safe small voltage in
accordance with the type plate.
– Use the charger in a room only.
– The adaptor supplied with this appliance is intended for this appliance only, do not use
it for other purposes.
– The power cord must not be damaged with sharp or hot objects, open fire, it must not
be sunk into water or bent over sharp edges.
II. EQUIPMENT AND ACCESSORIES OF VACUUM CLEANER
(Fig. 1).
A – vacuum cleaner
A1 –
ON–OFF
button
A4 – holder
A2 – light signaling
A5 – power supply socket
A3 – container lock button
B – dust container
B1 – filter
B2 – filter protector
C – holder
D – brush adapter
E – slot adapter
F – rubber scraper
G – charged
III. PREPARATION AND USE OF THE VACUUM CLEANER
Remove all the packing material, take out the vacuum cleaner and the accessories.
Fastening of the holder to the wall
Fasten the holder
C
close enough to the electric socket using bonding material (Fig.3). Make sure
that there is no electric, telephone, plumbing fittings under the plaster at the place of mounting
the holder. You can also place the holder on a horizontal surface, such as a table, etc. Holder
must be placed or fixed in flat position otherwise vacuum cleaner can fall down and caused
injury. Then slide the vacuum cleaner
A
to the holder together with the accessories (
D
,
E
,
F
).
GB
GB - 23
