29
7.35
The following steps should be taken to prepare your log splitter for storage.
7.36
Drain the fuel from the fuel tank, then run the machine until the engine comes to a stop.
This allows the carburetor to be emptied of fuel.
7.37
Disconnect the HT lead and remove the spark plug.
7.38
Pour a teaspoon of fresh engine oil down the spark plug cylinder bore.
7.39
Place a clean, lint free cloth over the spark plug hole and pull the recoil starter handle a
few times to allow the oil to coat the cylinder bore. Then replace the spark plug but
DO
NOT
replace the HT lead.
7.40
Clean the splitter completely and make sure all moving parts are lubricated.
DO NOT
use a hose pipe or pressure washer to clean the log splitter as water could
penetrate vital components and cause damage.
7.41
Check the machine to make sure that it is ready for the following season.
Replace or repair as necessary.
7.42
Once all work above is carried out store the machine in a clean and dry place away
from sources of ignition.
DO NOT
store a machine that has not been given time to fully cool down.
8. 0
Ensure the machine is turned off and the spark plug HT lead cap has been removed.
8.1
Make sure no fuel is allowed to leak during transport.
8.2
Secure the machine so it will not move during transport.
8.3
Never try to lift or carry the machine on your own. Always use assistance.
STORAGE
9. TRANSPORTING