HYUNDAI
07
4. JUMP STARTING
1) This unit is only for emergency use, not for frequent commercial use! Do not attempt to jumpstart your
vehicle when the HYJS-950 battery capacity is below 30%.
2) Turn off the vehicle ignition and all accessories (radios, lights, air conditioners, etc.), and disconnect
electronic devices.
3) Identify polarity of battery posts. The positive battery terminal is typically marked by these letters or
symbol (POS,P,+). The negative battery terminal is typically marked by these letters or symbol (NEG,N,-).
4) Do not make any connections to the carburetor, fuel lines, or thin metal parts.
5) Identify if you have a negative or positive grounded vehicle. This can be done by identifying which
battery post (NEG or POS) is connected to the chassis.
6) For a negative grounded vehicle (most common): connect the RED POSITIVE jumper clamp first to the
positive battery terminal, then connect the BLACK NEGATIVE jumper clamp to the negative battery
terminal or vehicle chassis.
7) For a positive grounded vehicle (very uncommon): connect the BLACK NEGATIVE jumper clamp first to
the negative battery terminal, then connect the RED POSITIVE jumper clamp to the positive battery
terminal or vehicle chassis.
WARNING
: If you have connected the clamps backwards, an audio alarm will sound and the Warning LED
will be lit. Do NOT turn the ON/OFF switch to the ON position. Reverse the connections and the
audio alarm will stop. NEVER allow two clamps to touch together or connect to the same metal
when ON/OFF switch gets the ON position! The jump starting function does NOT have reverse
polarity protection or short circuit protection. Incorrect operation of your jump starter may
result in damage and personal injury.8) Turn the switch to the ON position.
9) Crank the engine for no more than 8 seconds. If the engine does not start, wait 3 minutes before
cranking again.
10) After the engine starts, immediately turn the switch to the OFF position and remove the HYJS-950 from
the battery.
!
