![background image](http://html1.mh-extra.com/html/hyundai/hych2400e/hych2400e_instruction-manual_2197038029.webp)
www.hyundaipowerproducts.co.uk
01646 687 880
Maintenance
29
Problem
Possible Cause
Possible Solution
The motor does not run
Safety switch
Check if the switch still
functions well
Power failure
Check the power supply cable,
the plug and the house fuse
The material to be chopped is
not drawn in
The material is jammed in the
feeding tunnel
Switch the shredder OFF.
Pull the material from the feed
funnel. Switch the shredder
back ON and re-feed thick
branches such as that the
blade does not immediately
engage the pre-cut notches
again.
Shredding material is too soft
Insert wood or shred dried
branches
Press the reset button and
then the ON / OFF switch. If
it still does not start, take the
steps indicated in the
‘Overload Protection’ section.
Service
• Only have your electrical tools repaired by qualified specialists and with original replacement
parts. This ensures that the safety of the electrical tool is maintained. Do not attempt to repair the
machine unless you are qualified to do so.
Troubleshooting