Operator's Manual
Hyundai HYBCF31 Brush Cutter & Grass Trimmer
4.
Remove the allen key.
WARNING!
Never use non-recommended cutting attachments always ensure appropriate guards
.
The non-approved cutting attachments may cause serous injure during working.
Before use
Please always read the instruction manual carefully and check the machine before operating.
WARNING!
Ensure that the engine has oil. When leaving the factory. This machine has NO OIL in the engine. Check the
cutting attachment, never use blades that are blunt, cracked or damaged.
Make sure the handle and safety features are in good working order. Never use a machine that is missing any
part
WARNING!
Please always use quality hand, feet, ear and eye protection. They should have a CE mark and tested according
to PPE (Person Protective Equipment) directive.
The poor equipments may reduce the protection and result in personal injury during use.
Checking the engine oil
Before starting the machine, ensure the crank case is
to the top of the neck with either SAE30
or a 4 stroke oil.
1.
Before checking or
oil , be sure the machine is put on elevel ground.
2.
Make sure the machine is sw
3.
Remove the engine oil cap by rotating the cap anti-clockwise.
4.
If the oil level is below the top of the oil tank
or either
10w30 or 15w40 (Multiviscosity) 4 stroke oil.
5.
Screw in the engine oil cap.
WARNING!
The oil will be contaminated or discoloured during use. Please change the oil regularly.
For more information, please see clause:
MAINTENANCE
Never use 4-stroke oil intended for water-cooled engines.
Never use oil intended for 2-stroke engines.
A poor oil quality may jeopardise function and decrease the life time of catalytic converters.
Engine fuel
WARNING!
The brush cutter is
with a 4-stroke engine. Use straight unleaded petrol.
DO NOT
mix oil with
the petrol.
Only fuel the machine in well-lit areas. Avoid fuel spillage. Never refuel the machine during operation. Let the
control lamps or spark producing electrical equipment such as electric tools, welders or sanders.
1.
Make sure the machine is turned o by turning the engine switch to the “OFF” position.
2.
Check the fuel by a visual check , remove the fuel cap and reviewing the fuel level.
3.
Fill unleaded fuel from an approved fuel container into the fuel tank, because fuel expands,
please
the tank to the bottom of the neck of tank only.
4.
Turn the fuel cap clockwise to tighten it.
WARNING
●
Do not
fuel while engine is running or hot.
OPERATION
Page 11
Rev 3