1.3.
Electrical Safety.
1.3.1.
Do not touch the mains plug with wet hands! Always disconnect the mains plug by
pulling the plug and not the cable.
1.3.2.
The compressor must be connected to earthed sockets which have been properly
installed, earthed and tested. Mains voltage and fuse must comply with the technical
data.
1.3.3.
Do not kink, crush, drag or drive over the mains cable; protect against sharp edges,
oil and heat.
1.3.4.
Extension leads/cables must not be used.
1.3.5.
Disconnect the mains plug before all work on the appliance.
1.3.6.
Children and young people under the age of 16 years must not use this appliance,
and must be kept away from it when it is in operation.
1.3.7.
Repairs must be carried out only by a qualified electrician.
1.3.8.
If repairs are carried out incorrectly, there is a danger of liquid penetrating into the
electrical components of the appliance.
1.3.9.
Clean up all spills promptly using correct methods i.e. absorbent granules and a
lidded bin.
1.4.
General Safety Information.
1.4.1.
DO NOT operate the unit if it has been damaged either in transit or use.
1.4.2.
The Air Compressor and other components (filters, lubrication oils/greases, hoses
etc). The following safety precautions must be observed at all times.
1.4.2.1.
Read all manuals included with this product. Be thoroughly familiar with the
controls and proper use of equipment.
1.4.2.2.
Follow all electrical safety regulations – if in doubt contact a qualified
Electrician.
1.4.2.3.
Only persons well acquainted with these rules of safe operation should be
allowed to use the compressor and attachments.
1.4.2.4.
Keep visitors away and never allow children in the work area.
1.4.2.5.
Always wear safety glasses and hearing protection when operating the pump
or unit.
1.4.2.6.
Do not stand on or use the pump or unit as a handhold.
1.4.2.7.
Before each use, inspect the compressed air and electrical components for
signs of wear, damage, deterioration, weakness or air leakages. Always repair or
replace faulty items before use.
1.4.2.8.
Check all fasteners at frequent intervals for proper tightness.
1.4.2.9.
Keep fingers away from a running compressor, fast moving and hot parts will
cause injury and/or burns.
1.4.2.10.
If the equipment start abnormally, vibrate, STOP the motor and check
immediately for the cause. Vibration is a good warning of trouble with machine.
1.4.2.11.
To reduce fire hazards, keep motor exterior free from oil, solvents or
excessive grease. Never remove or attempt to adjust safety valve. Keep safety
valve free from paint and other dust and dirt.
Page 5
Ver 2
Summary of Contents for HY0808
Page 1: ......