8-32
REASSEMBLY
REASSEMBLY
For assembling, reverse disassembling
procedures. But pay attention to the
following.
Repair parts that were damaged at
disassembling.
Prepare replacement parts beforehand.
Contamination will cause malfunction.
Therefore, wash parts well with cleaning
oil, let them dry with jet air and handle
them in clean place.
Tighten screws, plugs, etc. with their
specified torques.
Replace seals such as O-ring with new
ones as a general rule.
4)
(1)
刮
刯
到
刱
Select a place for assembling.
Select clean place.
Spread rubber sheet or cloth to cover the
workbench to prevent parts from being
damaged.
(2)
侍
侍
Compensator section
Pilot section
Fit the compensator sleeve (622) and the
pilot sleeve (643) into the casing (601).
Make sure that the position of the
compensator sleeve (622) and the pilot
sleeve (643) are correct.
Confirm that these sleeves slide smoothly
in casing without sticking.
(3)
侍
侍
220S8MP38
