11
c. Grinding work
To perform your sanding work, install the appropriate disk according to the surface to be
sanded (ceiling, corner of the ceiling, different parts of a wall).
When sanding a wall up or a ceiling, use a ladder to reach the place to be sanded.
d. Sanding tips
-
Place the sander against the working surface with suitable strength.
-
Apply additional pressure for a stronger removal and reduce the pressure for a smoother
and more accurate finish.
-
Apply enough pressure to keep the sanding plate flat against the wall surface. However,
excessive pressure can cause rubbing marks or even irregularities on the worked surface.
-
Keep the sander in constant motion while holding the sanding plate in contact with the
surface to be sanded.
-
Use a steady, stable sweeping motion, balancing strength well.
Irregular movements
and even stopping on the working surface may create traces and irregularities.
-
Avoid moving the sanding plate against objects, such as nails, screws or electrical boxes
as they may damage the sanding plate.
e. Emptying the dust bag
The dust bag should be emptied and cleaned regularly. When the bag is half full or 2/3, empty
it and clean the interior walls. Emptying and cleaning the dust bag regularly is essential. A
lack of maintenance shall determine a decrease in the suction quality. The dust will then
come out through the sanding plate instead of getting into the bag.
-
Turn off and disconnect the tool.
-
The bag has a seam sealed by a plastic clip. Open the plastic clip and empty the dust into
a bin or other container.
-
Clean the bag if necessary and close it.
CARE AND MAINTENANCE
Turn off and unplug the tool from the power supply before any care and maintenance.
This tool does not require specific maintenance.
Regularly check the condition of the power cable, extension cords and cable plug. If the power cable
is damaged, it should be replaced by the manufacturer, its after-sales service or a similar qualified
person to avoid any danger. The device should not be used if these items are defective.
You can clean the device body with a soft, damp cloth.
Any other inspection shall be made by a qualified technician.
Contact the after-sales service, SWAP for any maintenance of the tool.
DISPOSAL
Electric power tools, as well as their accessories and packaging, must each be able to
follow an appropriate recycling pathway. Only for the countries of the European Union:
Do not throw away your electrical appliance with the household waste! In accordance with
the European Directive 2012/19/ EU on waste electrical and electronic equipment and its
implementation in national laws, power tools that can no longer be used must be separated
and follow an appropriate recycling pathway.
Summary of Contents for HPEP1010-1
Page 16: ......
