Hyundai HE-DX330, Service Manual

Page: 23 / 32

5.Troubleshooting
Problem Action
POWER
The power supply is disconnected.
¾ Please check if the AC power cord has been connected correctly.
¾
PICTURE
NO PICTURE
¾ Replace the breakage video cable before you turn on the player.
¾ Re-check if the connector of player has been properly connected to TV
set.
¾ Connect the video cable securely into the appropriate jacks and ensure
that the equipment is connected firmly.
¾ Ensure that the power of TV set is turned on.
¾ Make sure if the appropriate video input mode is selected on the TV, so
that the video image can be displayed on the screen properly.
Picture Distortion
¾ The disc is dusty and needs to be cleaned.
¾ It is normal for some distortion to occur when the Progressive Scan Mode
of Video Setup is selected, even if the TV set is compatible with the
progressive scan mode (525p). Therefore, please change the Scan Mode
to Interlaced Scan.
Picture not Suit TV Screen
¾ The troubled images may not be able to fill up the whole TV screen even
after the Picture Mode of the Video Menu is set. This is because the DVD
images are fixed in width.
SOUND
NO SOUND
¾ Check for the proper connections of the unit with the TV set and
amplifier.
¾ When the amplifier is connected, check if the amplifier power has been
turned on and if the cable has been inserted into the appropriate jack.
¾ Please change the audio cable with a new one if the cable is damaged.
¾ If the unit has been played in Slow or Pause mode, press
Play
to return to
the normal playback mode.
¾ If the unit is played in X2, X4, X8 mode, press
Play
to return to the
normal playback speed mode.
¾ When the unit is in System Setting Menu / Program Menu, press
Setup/
PROGRAM
to exit the system Menu / program menu.
¾ If the unit is in the mute mode, please press
Mute
again to enable the
normal sound play.
¾ Turn on the unit’s digital output if it is off.
¾ If the sound track 2 of the SVCD is not recorded, no sound will be output
when the track 2 is selected. Open up the Console Menu, and select track
1 for playback in the audio selection.
Distorted sound
¾
Make sure that the input settings for the TV and stereo system are correct
Noise
¾ The disc is dusty and needs to be cleaned.
¾ The noise comes from other interfaces except for DIGITAL OUT
OPTICAL or COAXIAL interface if the played CD is DTS standard.
No Stereo Sound Effect when Playing
Video CD or CD
¾ Check if the digital output is turned on.
¾ Press
R/L
to select stereo sound.
Operations
No output after turning on
¾ Ensure that the interval between continuous turning-on is not too short.
¾ Turn on the player again 10 seconds after it is turned off.
The screen doesn’t light,no output
¾ The player may have entered standby state, press
Power
on the remote
control to activate it.
¾ Turn on again 10 seconds after the power supply is switched off.