ENG
27
/ 36
26
DEFINING BEARD, MOUSTACHE AND SIDEBURN
1) Be certain the Clipper is in the OFF position.
2) Put the sprecision trimmer attachment on the Clipper. You will hear a click.
3) Hold the Clipper upright when you usethe precision trimmer attachment.
TRIMMING NOSE HAIR
1) Make sure nasal passages are clean.
2) Place nose, ear and eyebrow attachment on Clipper.
3) Switch the Clipper on and insert the tip of the attachment into one nostril.
CAUTION:
Do Not insert the tip more than 5mm into your nostril.
4) Slowly move the tip in and out while turning it around at the same time in order to remove
unwanted hair. For best results, make sure the side of the tip is firm against skin. This will
reduce the tickling effect that can occur during trimming of nose hair.
5) Turn off Clipper. Wipe attachment clean after each use.
TRIMMING EAR HAIR
1) Clean outer area of ear and ear canal. Make sure it is free of wax.
2) Nose, ear and eyebrow attachment should be on the Clipper.
3) Switch the Clipper on and move the tip softly around the edge of ear to remove hairs extending
beyond the outer ear.
4) Carefully insert the tip into outer ear canal.
CAUTION:
Do not insert the tip further than 5 mm
into the ear as this could causedamage to the eardrum.
5) Turn off Clipper. Wipe attachment clean after each use.
TRIMMING EYEBROW
1) Nose, ear and eyebrow attachment should be on Clipper
2) Switch the Clipper on and use the tip to cut individual eyebrow hairs.
3) The Clipper can be used for clipping single long hairs.
4) Put the Clipper at the root of the hair and move it along the edge of the eyebrow from the base
of the nose towards the outer tip of the eyebrow in the direction of hair growth.
IMPORTANT:
Do not use the Clipper to define or trim the entire eyebrow. Do not try to trim your
eyelashes. Be careful not to get too close to your eyelashes and eyes!
5) Turn off Clipper. Wipe attachment clean after each use.
SHAVING WITH MICRO SHAVER ATTACHMENT
1) Put the micro shaver attachment on the clipper.
2) Use the narrow micro shaver to shave along contoured edges to remove any stubble while
creating a smooth welldefined beard line. Before using the micro shaver, always check it for
wear and damage. If the micro shaver shows signs of wear or damage, do not use it as injury
may occur. Do not use the micro shaver until it has been replaced. Gently press the micro
shaver onto the skin. Do not press too hard.
CLEANING, CARE & MAINTENANCE
NOTE: Always clean Grooming System attachments regularly to ensure maximum performance
and a proper operating life.
Cleaning attachments with water
1. Remove attachment.
2. Rinse ONLY the attachment under warm running water. DO NOT use hot water ad this might
cause damage.
