Hyundai H-VCRX50, Instruction Manual

Page: 9 / 24

9
.

WARNING!

Be sure to clean the container after each cleaning.

Never use the vacuum cleaner without installed filter and with damaged or dirty
filter. Otherwise, dust will fall into the motor and cause damage to the vacuum
cleaner.

Don’t use the vacuum cleaner if the container is filled to the mark “MAX”. When the
container is filled, dirty air clogs up the vacuum cleaner filter and the engine can
overheat and disable.

Don’t use the vacuum cleaner for cleaning of material debris such as cement,
whitewash, plaster, metal shavings and etc. These particles cause to the engine
damage.

Don’t wash vacuum cleaner parts in a dishwasher or a construction machine.
Cleaning and maintenance

ATTENTION!

The device may not be connected to the mains and must be switched off for
cleaning and maintenance!

Only the dust bin may be rinsed out. The device itself, the fi lters or the remote
control may not be immersed in water or in other liquids. Make sure that all parts
are completely dry before you place the dust bin back in the device!

None of the parts of the robotic vacuum cleaner are suitable for cleaning in the
washing machine or dishwasher!

When cleaning, do not use any corrosive or abrasive cleaners. They could damage
the surface.
Cleaning the housing

Remove any coarse dirt from the device.

Use a damp cloth to wipe the rubber lip on the nozzle.

If necessary, wipe the housing off with a damp cloth only.

Emptying the dust bin and cleaning the fi lters

For proper operation of the device, you should empty the dust bin and clean the fi
lters after every use.

You can knock out the fi lters and/or use the enclosed cleaning brush to brush them
out.

You can rinse the dust bin out with water.

Fold the handle on the dust bin up and use it to pull the dust bin out of the device.

Open the dust bin by folding the catch forward and pushing it up.

Empty the dust bin into a waste bin.

You should also clean the HEPA and dust fi lter after every use. They are located in
the dust bin.

Release both catches on the side and take the dust fi lter off of the HEPA fi lter.

Empty out any coarse dirt over a waste bin.

Insert both fi lters again. When inserting the fi lters, make sure that they are
properly secured!

If necessary, clean the dust bin with clean, warm water. Then let it dry completely
before putting it back in the device.When putting it back in the device, make sure
that the dust bin is properly seated in the dust bin compartment and that the
handle is folded down.