Hyundai H-LCD804, Instruction Manual

Page: 12 / 28

12
a. Position: Please choose the number of channel you want to set.
b. Remember: Turn on to remember the set channel.
c. Band: You may choose the band where to search the channel. You can choose
V-L, V-H, UHF.
d. Swap: Press CH +/- to choose the program swap item. The function allows you
to swap the current channel number to another one. Press CH +/- to choose
target channel (it means the channel has been chosen, when the color of the
channel number's change to red), press VOL +/- to add or reduce the number,
then press CH +/- to choose current channel number, press VOL +/- to realize
the function.
e. Fine: press CH +/- to choose this item, then press VOL +/-, you can adjust the
program conditions while you are watching by hand.
f. Search: press CH +/- to choose this item, then press VOL +/- to proceed to
search channels by hand.
g. Auto-Search: the original set is auto search, press VOL +/- to make it auto
search. It would search all the currently TV channels and store them.
Caution:
1. When performing manual search, press VOL +/- can reverse the searching
direction. Press MENU to stop manual search.
2. Use CH +/- to select channel number. If a channel is preset, the channel number
will become red.
Note:
1. Hue setting applies to NTSC input only.
2. Volume can simply be adjusted by pressing VOL +/-.
3. OSD menu will automatically exit in 10 seconds.
In order to receive clearer picture
Adjust the length, angle and direction of the telescopic antenna to obtain optimum
image. Draw back the antenna from the butt end after usage.
!
Caution
In case the signal intensity is too weak, the image will remain inferior whatever you
adjust the antenna, and cause loud noise wave, shaking image and inferior sound, etc.,
which is not TV fault. If the image remains inferior when using telescopic antenna,
please try to use the external antenna or CATV.