Hyundai H-CCR8091, Instruction Manual

Page: 10 / 27

Operation
10
Audio parameter setting
Press SELECT button repeatedly
to select a parameter: VOL (volume)
=> BAS (bass) => TRE (treble) =>
BAL (balance) => FAD (fader). Rotate
VOLUME knob to adjust each mode:
• Bass/Treble: from -6 to 6;
• Balance: L06 (left) to R06 (right);
• Fader: from R06 (rear) to F06
(front).
When equalizer is in any mode
except FLAT, bass and treble are not
adjustable.
Preset equalizer modes
Press SELECT button repeatedly
until FLAT/ROCK/POP/CLASS or
JAZZ equalizer mode is displayed.
Rotate VOLUME regulator to select
equalizer mode.
Clock
Press and hold CLK button to
display the time on the screen. Then
press and hold this button again;
the hour indication will blink. Rotate
VOLUME regulator to adjust hours;
press CLK button to go to minutes;
rotate VOLUME regulator to adjust
minutes. To confirm the adjustment,
press CLK button or leave the unit idle
for several seconds.
Aux input
AUX-in jack is intended for
connecting an external audio
equipment to amplify the sound. If
connection is made correctly, the
audio signal from the external source
will be translated through the acoustics
of the head unit. This enables to
adjust the volume and quality of the
sounding. For example, you can
connect an MP3-player to listen to
tracks using the car acoustic system.
Radio operations
Band select
In Radio mode press BND/MEM
button to select a radio band: F1
(FM1), F2 (FM2), F3 (FM3). 6 stations
can be saved in each band.
Manual/automatical tuning
• Press / buttons
repeatedly to adjust the needed
frequency manually.
• Press and hold or
button. The radio will seek to the next
down or up strong and clear frequency
station.
Storing and recalling stations
• Press and hold APS/
button for more than 2 seconds
to automatically find and store 6
strongest stations in the current band.
• After 6 strongest stations are
saved, press APS/ button; scanning
of all stored stations will begin.
• Press CH-/10- and CH+/10+
buttons to select saved channels. If
you want to save a new station in a
preset position, select corresponding
station number with CH-/10- and
CH+/10+ buttons. Then tune to the
needed frequency as described in
“Manual/automatical tuning“ above
and press and hold BND/MEM button.
The new frequency will be saved in
the selected position.