Hyundai Elantra GT 2018, Owner'S Manual

Page: 110 / 478

3-25
Con
v
enient f
eatur
es of y
our v
ehicle
3
2. Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
away from the HomeLink
® button
you wish to program while keeping
the indicator light in view.
3. Simultaneously press and hold
both the HomeLink ® and hand-
held transmitter buttons until the
HomeLink
® indicator light changes
from a slow to a rapid blinking
light. Now you may release both
the HomeLink
® and hand-held
transmitter buttons.
Information
Some devices may require you to
replace this Programming step 3 with
procedures noted in the "Gate
Operator/Canadian Programming"
chapter. If the HomeLink
®
indicator
light does not change to a rapidly
blinking light after performing these
steps, contact HomeLink
®
at
www.homelink.com.
4. Press and hold for 5 seconds then
release the programmed HomeLink ®
button up to two separate times to
activate the door. If the door does not
activate, press and hold the just-
trained HomeLink
® button and
observe the indicator light.
• If the indicator light stays on con-
stantly, programming is complete
and your device should activate
when the HomeLink
®
button is
pressed and released.
• If the indicator light blinks rapidly
for 2 seconds and then turns to a
constant light, continue with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code equipped device (most com-
monly a garage door opener).
5. At the garage door opener receiver
(motor-head unit) in the garage,
locate the "learn" or "smart" button.
This can usually be found where
the hanging antenna wire is
attached to the motor-head unit.
i
ODH044414N
Flashing