Turning on the Appliance
Starting a wash cycle
- Make sure that the plug for the appliance is inserted into the
wall socket.
- Make sure that the water supply is turned on to full pressure.
- Load the dishwasher (see the section entitled, "Loading the
Dishwasher").
- Pour in the detergent (see the section entitled, "Salt, Detergent
and Rinse Aid").
- Turn the knob located on the right of the control panel in
clockwise direction until the number or symbol for the cycle
setting is aligned with the reference mark (see the section
entitled, "Wash Cycle Table").
- Press the ON-OFF button, and the ON-OFF light will turn on.
At this point, the wash cycle will begin.
Cancelling or modifying a wash cycle setting
A cycle that is underway can only be modified if it has been run-
ning for a short time. Otherwise, the detergent may have already
been used, and the appliance may have already drained the wash
water. If this is the case, the detergent dispenser must be refilled
(see the paragraph entitled, "Loading the Detergent").
Press the ON-OFF button, and the ON light will turn off. Rotate
the knob in clockwise direction to the desired cycle setting (see
the section entitled: Starting a wash cycle
. Then, turn the
dishwasher back on using the ON-OFF button.
Wash Cycle Adjustment Buttons
"ECO" Button
This button (see "Close-up View - Control Panel", letter "B" ) is
used for normal dirty dishes, pots and pans. It is a standard daily
cycle.
At the end of the wash cycle
When the knob stops turning and is aligned with a STOP mark
(see figure), the cycle has finished. Turn off the appliance using
the ON-OFF button, turn off the water supply and open the door
of the dishwasher.
.6.
GB
Wait a few minutes before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better.
Half load Button
This button (see "Close-up View - Control Panel", letter "C" ) makes
it possible to wash dishes using only the upper rack if there are
not enough dishes for a full load. This will allow you to save on
water and electricity.
It can be used before setting any of the wash cycles. Please
keep in mind that the amount of detergent should also be cut in
half.
