Specialty Required Tools
FMVSS110 Compliance Information
Rev. Date
English
8/22/2018
Instructional Symbols /
Definitions
WARNING: Do NOT install Standard Roof Crossbar Set on a Panoramic Roof vehicle.
* For Standard Roof models use Part No. D3021 ADU02:
Do not exceed manufacturer’s roof load limit of 220 lbs / 100 Kg
* For Panoramic Roof models use Part No. D3121 ADU01:
Do not exceed manufacturer’s roof load limit of 220 lbs / 100 Kg
Wrench (Included)
All dealers must determine if the weight they
have added in the form of all options or
accessories, when added to the weight of all
Port/Dealer Installed options or accessories,
exceeds the lesser of 1.5% of GVWR or 100
lbs. If the additional weight does exceed the
lesser of the indicated thresholds, a "Load
Carrying Capacity Reduced" label must be
installed. A black, fine-point, indelible marker
must be used to write by hand onto the label,
the reduced carrying capacity in kilograms or
pounds, which is the total weight of all added
options and accessories.
Load Label Part Number: NP070 - 09003
Part Number:
D3021 ADU02
5.73 lbs
2.60 kg
(Gross Weight)
Part Number:
D3121 ADU01
6.17 lbs
2.80 kg
(Gross Weight)
Coin
Genuine Accessories
Step Ladder
Clean Cloth
Basic Required Hand Tools
Part No.
D3021 ADU02 (Standard Roof)
Tape Measure
Vehicle Model: Tucson
Accessory: Crossbar Set
Model Year
2016 ~
Difficulty
( A )
Difficulty stated above reflects the minimum level of expertise required to install the accessory.
( A ) Customer ( B ) Dealer Technician ( C ) Master Technician
Note:
D3121 ADU01 (Panoramic Roof)
Language
REGULARLY CHECK THE TIGHTNESS BY PERFORMING A TUG ON THE CROSSBARS.
THEY SHOULD NOT MOVE. If crossbars move, see step 5 for proper tightening. Incorrect clamp tightness can cause crossbar
separation from vehicle resulting in product failure and vehicle damage. Serious physical injury may occur.
Loads must be evenly distributed and secured.
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle should therefore be
driven with increased caution.
Only use NON-STRETCH tie down straps. Use of stretch elastic tie downs may cause loss of load, potential serious injury, and vehicle damage.
Denotes safety equipment required to be
used such as a mask, safety glasses,
gloves, and hearing protection.
Safety Glasses
Hearing Protection
Mask
Gloves
Denotes instructional steps necessary
to complete the process.
Denotes quality processes to be checked
prior to moving to the next step.
Denotes cautions to be taken to
avoid physical injury or electronic
component damage.
Denotes warnings that may lead to
serious physical injury or vehicle
damage.
Denotes specific tools that are necessary to
complete the step.
Denotes cautions to be taken to
avoid vehicle and component
damage.
Notes to the Installer:
1) Read the entire installation instructions prior to beginning the installation of this accessory.
2) Make sure the vehicle is completely clean before the accessory is installed.
3) Ensure the vehicle is properly protected in the area(s) that the accessory is to be installed.
4) To prevent vehicle damage, never place tools on top of painted surfaces, seats, dash pad, console or floor carpet/mats.
5) Always wear appropriate safety gear including gloves and safety glasses when required.
6) Confirm correct Crossbar Kit P/N with vehicle roof type application before installing.
Revision Date
08/22/2018
Page 1 of 6
