CONTROLS AND EQUIPMENT
1- 5
HGK102-D
B070E01GK-GAT
Replacing the battery
When the transmitter's battery begins to get
weak, it may take several pushes on the button
to lock or unlock the doors, and the LED will not
light. Replace the battery as soon as possible.
Battery type : CR2032
Replacement instructions:
1. Seperate the case with a blade screwdriver
as shown in the illustration.
B070D01GK-AAT
Disarmed Stage
The system will be disarmed when either of the
following steps are taken:
1) The driver's or passenger's door is unlocked
by depressing the "UNLOCK" button on the
transmitter.
2) In the middle of arming or after armed, it
keeps for 30 seconds with the key is turned to
the "ON" position.
After completing steps above, the turn signal
lamp will blink twice to indicate that the system is
disarmed.
NOTE:
Once the system has been disarmed, it can
not be rearmed except by repeating the arm-
ing procedures.
HGK122
Screwdriver
2. Remove the old battery from the case and
note the polarity. Make sure the polarity of the
new battery is the same(+side facing down),
then insert it in the transmitter.
NOTE:
Replace a new battery within 30 seconds
after remove the old one, if you replace a new
battery after 30 seconds, take the following
steps.
1) Turn the ignition key to the "ACC" posi-
tion.
2) Make sure that the turn signal lamp blink
once by pushing the "LOCK" or "UN-
LOCK" button on the transmitter.
HGK121
Battery