Hyundai power products HTDT46-2, Original Instructions Manual

Page: 13 / 17

13
6. MAINTENANCE ANDSTORAGE
Before working on the cutting system of the machine, switch off the engine and
remove the spark plug’s cap.
a. Cleaning the mower
- Cut grass is damp. Regular cleaning after each use will ensure better functioning of
the mower and reduce the risk of corrosion or seizure.
- Having finished mowing, allow the engine to cool then remove accumulated grass
clippings from and around the engine with a brush.
- Clean the grass collection bag annually with a brush or gentle spray of water.
- Disconnect the spark plug’s cap and tilt the mower on its side with the air filter and
carburettor uppermost.
- Remove any remaining cut grass from the cutting system with a scraper and a
brush.
- Reposition the mower onto its four wheels.
- Do not use a pressure washer or hot water to clean the mower. Be careful to avoid
soaking parts such as the engine, air cleaner, wheel bearings and metal fastenings.
Dry off the machine before storing by leaving it running for a few minutes on a flat,
clear surface to prevent corrosion or seizure.
b. Storing the mower
Store your mower in a dry, well-ventilated area, away from flames, sparks or heat sources.
If the storage area is accessible to children, immobilise the machine by
disconnecting the spark plug’s cap. Storing the mower beneath a tarpaulin or similar
cover is not recommended as it may cause a build
‐
up of condensation resulting in
corrosion of the mower.
Extended shutdown and winter storage
Thoroughly clean the mower. Ideally, run the engine outdoors until the fuel tank is empty.
Alternatively, empty any remaining fuel using a fuel suction pump.
Dispose of discarded fuel safely and responsibly, remembering that petrol vapours can
cause explosion or fire. Run the engine until any remaining fuel is consumed. Allow the
engine to cool. Check the condition and cleanliness of the air cleaner. Remove the spark
plug from the engine and pour a tablespoon of engine oil into the cylinder. Gently pull the
starter rope several times to turn over the engine, distributing the oil to protect the
cylinder over winter. Replace and tighten the sparkplug.
At the start of the new season
Remove the spark plug and gently clean off any carbon deposits from the tip with a small
copper wire brush, finishing off with petrol. Allow the spark plug to dry. Pull the starter
rope several times to expel excess oil from the cylinder. Replace and tighten the spark
plug. Fill the fuel tank with unleaded petrol. Turn over the engine until it starts.
Before transporting the mower
Thoroughly clean the mower. Empty the fuel tank using a suction pump. Dispose of
discarded fuel safely and responsibly, remembering that petrol vapours can cause
explosion or fire. Run the engine until any remaining fuel is consumed.
Allow the engine to cool. Remove the grass collection bag. Loosen the quick release and
fold down the top section of the handles taking care not to bend the cables.
To avoid scratching the mower, insert corrugated cardboard or similar padding between
the upper and lower handlebars and the engine.
Due to the mower’s weight, use ramps or seek assistance when lifting or loading the
mower.