Hyundai power products HTDE511RP, Original Instructions Manual, Page: 17 / 23

OPERATION
Note: Use a residual current device (RCD) rated for a residual current not greater than 30 mA.
Important! The front and back wheels must be set to the same height.
Starting and Stopping
The blade continues to rotate for a few seconds after the machine is switched off.
Allow the motor/blade to stop rotating before switching “on” again. Do not rapidly
switch off and on.
Starting:
1. Press and hold the safety button.
2. Squeeze the switch lever towards the handle.
3. Release the safety button.
Stopping:
Release the switch lever.
Mowing:
Position the cable to opposite side (already cut) at the end of each turn.
When mowing, do not allow the motor to labor particularly in heavy conditions. When the motor
labors the speed of the motor drops and you will hear a change in the motor sound, when this
occurs stop mowing, release the switch lever and raise the height of cut. Failure to do so could
damage the machine.
MAINTENANCE
Cleaning
Note: Disconnect electricity by unplugging cable at the socket before proceeding.
Attention: keep hands clear of moving blade.
Clean mower thoroughly after each mowing with cloth or brush.
Do not spray with water.
Winter storage
- Clean mower thoroughly before storing away.
- Have your mower thoroughly checked once a year by an approved service center
- Do not store it in a wet or humid place.
- Keep all nuts, bolts, and screws tight to be sure the appliance is in safe working
condition.
- Check the grass catcher frequently for wear or deterioration.
- Replace worn or damaged parts for safety.
Change of cutter blade
Stop, remove plug from the power supply and remove the collector.
If the blade is blunt, it can be sharpened by a specialist workshop. If the blade is damaged or
showing signs of imbalance, it must be replaced.
1. Turn the equipment over.
2. Use sturdy gloves and hold the blade firmly (29). Use a spanner to turn the blade bolt (30)
counter-clockwise from the motor spindle.
3. Install the new blade in the reverse order. Ensure that the blade is positioned correctly and
the screw tightened firmly.
17