Hytera BD302i, Owner'S Manual

Page: 10 / 27

4
Attaching the Belt Clip
1. Unfasten the two screws on the back of the radio.
2. Align the screw holes on the belt clip with those on the back of the
radio.
3. Tighten the screws.
Attaching the Audio Accessories
1. Open the accessory connector cover.
2. Plug the accessory into the accessory connector.
3. Rotate the accessory plug clockwise into place.
Charging the Battery
Be sure to charge the battery fully before initial use, since reduction of
state of charge (SoC) may lead to low battery alarm. It is recommended
that your radio remain powered off during charging.
To charge the battery, insert the USB plug of the power adapter into the
USB connector of the radio, and then connect the power adapter to the
main supply.
The charging indicator on the radio shows the charging status. For
details, see the following table.
Charging Indicator Charging Status
Glows red The battery is charging.
Glows green The battery is fully charged.
Checking the Battery Power
You can check the current battery power by holding down the Battery
Power Indicator key programmed by your dealer, and release the key to
exit. The following table lists battery power indications:
LED Indicator Alert Tone Battery Power
Glows green Three beeps High
Glows orange Two beeps Medium
Glows red One beep Low
Flashes red Low battery tone
Under the low battery
threshold. Please
recharge or replace the
battery.
Before Use