Installation Tools
The following tools are required for proper installation of
your radio:
z
Electric drill:
¡é
6mm or above
z
Cross head Screwdriver
¡ö
¡ö
¡ö
¡ö
¡ö
Warnings:
1. The radio operates in 13.6
¡À
5
£¥
V negative ground
systems only. Check the voltage and polarity of the
power supply on the vehicle before installation.
2. Be sure to check how far the screw will extend below
the radio surface to avoid damage to the auto wiring or
auto parts when drilling mounting holes.
3. Connect the radio with the supplied antenna and power
cable before installing the radio by the mounting bracket.
4. Install the radio securely using the supplied mounting
bracket to make sure that the radio will not loosen in the
event of accidents. The loose radio may cause injury to
the passenger.
Radio Installation
5. Arrange the installation location of the radio to make
sure that the control unit in the front panel is convenient
for operation.
6. Be sure to determine the location of the installing holes
before installation and drilling.
7. Be sure to make room at the rear of the radio for power
cable connection.
8. When replacing the fuse in the DC power cable, be
sure to replace it with a fuse of the same value. Never
replace a fuse with one that has a higher value.
9
ＴＭ８００．ｐ６５
2005-6-29, 10:16
10
