Maintenance Procedures Every 2000 Hours or Yearly
8000 SRM 707
WARNING
Brake linings can contain dangerous fibers.
Breathing the dust from these brake linings
is a cancer or lung disease hazard.
Do not
create dust!
Do not clean brake parts with
compressed air or by brushing.
Follow the
cleaning procedure in this section. When the
brake drums are removed, do not create dust.
Do not sand, grind, chisel, hammer, or change
linings in any way that will create dust. Any
changes to brake linings must be done in a re-
stricted area with special ventilation. Protec-
tive clothing and a respirator must be used.
Cleaning Procedures:
CAUTION
Do not use an oil solvent to clean the wheel
cylinder. Use a solvent approved for cleaning
of brake parts. Do not permit oil or grease in
the brake fluid or on the brake linings.
1.
Do not release brake lining dust from brake lin-
ings into the air when brake drum is removed.
2.
Use a solvent approved for cleaning of brake
parts to wet lining dust. Follow the instructions
and cautions of the manufacturer for the use of
the solvent. If a solvent spray is used, do not
create brake lining dust with the spray.
3.
When the brake lining dust is wet, clean parts.
Put any cloth or towels in a plastic bag or an
airtight container while they are still wet. Put
a DANGEROUS FIBERS warning label on the
plastic bag or airtight container.
4.
Any cleaning cloths that will be washed must be
cleaned so that fibers are not released into the
air.
DIFFERENTIAL
NOTE:
Additional information can be found in Drive
Axle 1400 SRM 499.
Change oil in differential and drive axle. The differ-
ential and drive axle use the same oil supply. The oil
level must be even with the bottom of the fill hole.
The fill hole for checking the oil level is on the front
of the differential housing.
Add oil shown in the
Maintenance Schedule. Install fill plug and check for
leaks.
LPG FUEL FILTER REPLACE, (PRE-2004)
WARNING
LPG is flammable.
Make sure there are no
sparks or open flames in the area when the
fuel line is drained.
Install a new LPG filter as follows: (See Figure 38)
1.
Close fuel valve on tank. Run engine until all fuel
is gone and engine stops.
2.
Slowly loosen hose fitting to filter. Let any fuel
drain from fitting before disassembling filter
unit.
3.
Remove screw and filter cover. Install filter ele-
ment.
4.
Install cover and gasket.
Tighten screws for
cover. Tighten hose fitting.
1.
FILTER ELEMENT
Figure 38. LPG Fuel Filter (Pre-2004)
GASOLINE FUEL FILTER
Install new fuel filter. After installation, operate en-
gine and check for leaks. See Figure 11.
FUEL FILTER (AISAN LPG SYSTEM),
REPLACE
1.
Close shutoff valve on tank. Run engine until it
stops.
2.
Remove six capscrews, cover, and two filter ele-
ments. Discard filter elements.
50